Advertisement
FOR YOUR SAFETY READ bEFORE LIGHTING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
A. This appliance must be lighted with the remote control.
When lighting the pilot, follow these instructions exactly.
b. bEFORE LIGHTING, smell around the appliance area for
gas. Be sure to smell next to the floor because some
gases are heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch.
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions. If you can not reach your gas
supplier, call the fire department.
1.
STOP! Read the safety information above.
2.
Turn OFF electric power to the appliance.
3.
Turn gas shut-off knob counterclockwise
"ON" position.
4.
Wait ten minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow
"B" in the safety information above on this label. If you
do not smell gas, go to the next step.
5.
Turn ON electric power to the appliance.
6.
Using the remote control, turn main flame to "ON." Refer
to the Multifunction Remote Operating Instructions for
more information. If the pilot does not light within 60
seconds, stop and go back to Step 4.
1.
Turn off all electric power to the appliance if service is to
be performed (if applicable).
Page 10
LIGHTING INSTRUCTIONS
LIGHTING INSTRUCTIONS
IGNITOR
TO TURN OFF GAS TO APPLIANCE
WARNING
C. Use only the remote control to operate the valve. Never
use tools. If valve does not operate, don't try to repair it,
call a qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been underwater.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been underwater.
7.
Refer to remote control instructions for detailed
information, control features, and operation. Note:
Refer to Multifunction Remote operating instructions
to
for selection of continuous standing pilot mode or
intermittent pilot mode. If the pilot or burner does not stay
lit (in the standing pilot mode), stop and immediately call
a qualified service technician or gas supplier.
8.
If the burner or pilot does not operate properly after
several tries, turn the gas shut-off knob clockwise
to "OFF" and call your service technician or
gas supplier.
9.
Operation of the gas valve, blower, and/or optional light
must be controlled by using the hand held remote control.
Refer to remote instructions for detailed operation
information.
GAS SHUT-OFF vALvE
2.
Locate On/Off gas shut-off knob and turn clockwise to
"OFF." Do not force.
41417-1-0220
Advertisement
