Table of Contents
Advertisement
Power Outlet
P
SETTING
After you finish assembling the stand, turn on the
Digital Piano. For details, see "Getting Ready" on page
EN-61.
Turning Power On or Off
1.
Press the P (Power) button to turn on Digital
Piano power.
• If you press P (Power) button only lightly, the
display will light up momentarily but power will not
turn on. This does not indicate malfunction. Press P
(Power) button firmly and completely to turn on
power.
2.
To turn off the Digital Piano, hold down the
P (Power) button until the Digital Piano's
display goes blank.
• You can configure the Digital Piano to save its setup
when power is turned off. For details, see
"Configuring Digital Piano Settings" on page EN-44,
and "General" 3 "Auto Resume" in the "Parameter
List" on page EN-48.
EN-6
u, q, w, i
ENTER
VOLUME
• Pressing the P (Power) button to turn off power
actually puts the Digital Piano into a standby state.
Minute amounts of current continue to flow within the
Digital Piano in the standby state. If you do not plan
to use the Digital Piano for a long time or if there is a
lightning storm in your area, be sure to unplug the
AC adaptor from the power outlet.
• The message "Please Wait..." will remain on the
display while a data save operation is in progress.
Do not perform any other operation while it is
displayed. Turning off the Digital Piano can cause
Digital Piano data to be deleted or become
corrupted.
Auto Power Off
This Digital Piano is designed to turn off automatically
to avoid wasting power after no operation is
performed for a preset amount of time. The Auto
Power Off trigger time is about four hours.
• You also can use the procedure below to temporarily
suspend Auto Power Off.
■ To disable Auto Power Off
1.
Press the SETTING button to display the
setting screen.
2.
Use the q and w arrow buttons to select
"General" and then press the ENTER button.
G e n e r a l > E n t
3.
Use the q and w arrow buttons to select
"Auto Power Off".
4.
Use the u and i arrow buttons to select
"Off".
5.
Press the SETTING button to exit the setting
screen.
• To re-enable Auto Power Off, perform the above
procedure and select "On" in step 4.
Advertisement
Table of Contents
