Table of Contents
Advertisement
Getting Ready
1.
Unfasten the band
cable to the back of crosspiece
the pedal cord out from the crosspiece.
1
Pedal cable
2.
Attach side panels
. Secure the side panels using four screws
.
• When installing parts
the slots in either end of crosspiece
are not inserted into the ends of the crosspiece
as far as they will go, the screws
enter into the screw holes of the brackets
can strip the threads of the screws.
• Cover the screw heads with the caps
EN-62
that bundles the pedal
and pull
and
to crosspiece
, slide the brackets
into
. If the brackets
will not be able to
, which
.
3.
Slide back panel
the side panels.
• When installing back panel
high screw holes of the back panel are to the right,
and the low screw holes are to the left.
Low
4.
Attach the left side of back panel
bracket
side to side panel
screws to hold the back panel in place
temporarily.
• When inserting the screws, you will need to lift up
back panel
the screw holes of the brackets
• At location
before installing the screw.
into the grooves
, make sure that the
of side panel
, and the right
. Partially tighten two
so its screw holes become aligned with
.
, slip the clip
onto to the screw
of
High
to the
Advertisement
Table of Contents
