Table of Contents
Advertisement
5.
Next, secure the bottom of the back panel
with the three
screws.
• If you cannot see the screw holes along the bottom
the back panel
, slide the back panel
or right.
6.
Securely tighten the
tightened in step 4 above.
7.
Adjust the height adjustment screw
provide support so crosspiece
bow downwards when the pedals are
pressed.
• Pressing the pedals without first adjusting height
adjustment screw
can result in abnormal noise
and/or damage to crosspiece
height adjustment screw
to the left
screws you partially
to
does not
. Be sure to adjust
.
8.
Place the piano onto the stand.
• In order to ensure you do not get your fingers
pinched between the piano and the stand, grasp the
piano on its sides (not its ends) at the locations
marked with stars () in the illustration.
At least 10cm
• Place the piano onto the stand starting the Digital
Piano unit as much to the front of the stand as
possible, and then slide it into place. Take care to
avoid contact between the speaker boxes on the left
and right sides on the bottom of the Digital Piano and
the stand.
• At this time the screws on the bottom of the piano
should hook into the cutouts in the stand brackets
Bracket cutout
Getting Ready
At least 10cm
Back of piano
Stand side panel
EN-63
.
Advertisement
Table of Contents
