If The Problem Persists - 3Com 2426-PWR Installation And User Manual

The Link/Activity LED is on, but network
performance is poor
The Switch supports full-duplex autonegotiation. If the
connected device does not support autonegotiation,
ensure that it is configured for half-duplex operation
only. If the connected device has autonegotiation dis-
abled or overridden, and is configured as full-duplex,
the Switch will configure the link as half-duplex, caus-
ing a mismatch that will reduce network performance
when data is transmitting and receiving simultaneously
on the same link.
Ensure that the connected device has either:
Autonegotiation enabled, or
■
The ports are configured for half-duplex operation
■
All ports appear to show continual activity.
There may be broadcast storms on the network.
Remove port connections one at a time, waiting a few
seconds between each port. If the LEDs go off after
removing a port connection, the device that was con-
nected to that port is introducing an excessive amount
of broadcast frames to the network. Some pieces of
network equipment operate by sending out broadcast
frames regularly.
Refer to the documentation that accompanies the
device for information on disabling the broadcast
operation.

If the Problem Persists

If the problem persists and the unit still does not oper-
ate successfully, contact your 3Com network supplier
with the following information before returning the
unit:
Product number and serial number (printed on a
■
label supplied with the unit).
A brief description of the issue
■
If the Problem Persists 77