Seat Belts And Child Restraint Systems - Suzuki 2009 SX4 SEDAN Owner's Manual

Seat Belts and Child Restraint Systems: 3

Rear
EXAMPLE
Your vehicle is equipped with three head
restraints on the rear seat.
EXAMPLE
(1)
(2)
(1) head restraint
(2) bars
(3) release knob
To raise the rear head restraint, pull
upward on the restraint until it clicks. To
lower the restraint, push down on the
restraint while holding in the release knob
(3). If a head restraint must be removed
(for cleaning, replacement, etc.), push in
the release knob and pull the head
restraint all the way out.
When installing a child restraint system,
raise the head restraint to the most upper
position.
For SX4 SEDAN, if the distance between
the child restraint system and the anchor
bracket is too close to properly tighten the
80J2002
child restraint top strap, lower the head
restraint to the lowest position and connect
the top strap to the anchor bracket by
passing it over the top of the head
restraint.
NOTE:
(3)
It may be necessary to recline the seat-
back to provide enough overhead clear-
ance to remove the head restraint.
80J2005
BEFORE DRIVING
Seat Belts and Child Restraint
Systems
WARNING
An air bag supplements, or adds to,
the frontal crash protection offered
by seat belts. The driver and all pas-
sengers must be properly restrained
by wearing seat belts at all times,
whether or not an air bag is mounted
at their seating position, to minimize
the risk of severe injury or death in
the event of a crash.
80J22-03E
65D231
2-22