Automatic Transaxle Fluid: 10 - Suzuki 2009 SX4 SEDAN Owner's Manual

Hide thumbs Also See for 2009 SX4 SEDAN:
Table of Contents

Advertisement

Automatic Transaxle Fluid: 10

FULL
EXAMPLE
The handle of the engine oil dipstick is col-
ored yellow for easy identification.
Pull out the oil dipstick, wipe oil off with a
clean cloth, insert the dipstick all the way
into the engine, then remove it again. The
oil on the stick should be between the
upper and lower limits shown on the stick.
If the oil level indication is near the lower
limit, add enough oil to raise the level to the
upper limit.
Refilling
ADD
EXAMPLE
Open
52D084
Remove the oil filler cap and pour oil slowly
through the filler hole to bring the oil level
to the upper limit on the dipstick. Be careful
not to overfill. Too much oil is almost as
bad as too little oil. After refilling, start the
engine and allow it to idle for about a
minute. Stop the engine, wait about 5 min-
utes and check the oil level again.
INSPECTION AND MAINTENANCE
Changing Engine Oil and Filter
EXAMPLE
Close
81A147
Drain the engine oil while the engine is still
warm.
1) Remove the oil filler cap.
2) Place a drain pan under the drain plug.
3) Using a wrench, remove the drain plug
and drain out the engine oil.
WARNING
The engine oil temperature may be
high enough to burn your fingers
when the drain plug is loosened. Wait
until the drain plug is cool enough to
touch with your bare hands.
60G306
9-12
80J22-03E

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents