Table of Contents
Advertisement
4 Connections
Connection example 1 for the auto adjustment time function
When "Auto time adjustment" found in "Date & time settings" under "Date/Language" on the setup menu is set to
"Master".
"Time adjustment output" becomes available and the clock of this recorder will be applied to other devices.
The time adjust output signal will be supplied from B3 terminal to other recorders at the time set for "Activation time" of "Time &
date" under "Basic" on the setup menu.
B10
Connection example 2 for the auto adjustment time function
When "Auto time adjustment" found in "Date & time settings" under "Date/Language" on the setup menu is set to
"Slave".
When a signal output from the other device is supplied to the time adjustment I/O (B3 terminal) and the time difference between
the recorder and the other device is 29 minutes or less, the clock of the recorder will be set to the time set for the other device.
When a signal output is supplied to the recorder 29 minutes before/after the hour, the clock of the recorder will be set to the hour
(nn:00:00). ("nn" is the hour.)
Example:
• Signal is supplied at 2:50:00 pm → Set at 3:00:00 pm
• Signal input supplied at 3:28:45 pm → Set at 3:00:00 pm
• Signal is supplied at 3:29:30 pm → Time will not be adjusted.
B10
Important:
• When "Slave" is selected, the clock will not be adjusted during event recording or emergency recording.
(continued)
B3
(Time adjustment I/O)
(Signal ground)
B3
(Time adjustment I/O)
(Signal ground)
Terminal of the other device
Front panel
LED monitor
output
Terminal of the other device
Front panel
LED monitor
output
21
Advertisement
Table of Contents
