Pontiac 2010 Vibe Owner's Manual page 14

1-8 Keys, Doors and Windows
The security light is in the center of
the instrument panel.
Arming the System
To arm the system:
1. Close all the doors and the
liftgate.
2. Lock the doors and liftgate with
the key or Remote Keyless
Entry (RKE) transmitter.
The security light comes on
solid.
The system is armed after
30 seconds and the security
light will flash.
Unlocking the vehicle from the
inside activates the system.
To avoid setting off the alarm make
sure all passengers are out of
the vehicle and the windows are
closed before arming the system.
Disarming the System
To disarm the alarm do one of the
following:
•
Unlock the doors with the key.
•
Unlock the doors and liftgate with
the RKE transmitter.
•
Start the engine.
Testing the Alarm
To test the alarm:
1. Open all the windows.
2. Set the system by closing and
locking the doors and liftgate
with the RKE transmitter.
Wait until the security light is
flashing.
3. Unlock the driver door from
the inside. The system should
activate the alarm.
4. Stop the alarm as described in
the disarming procedure.
5. Repeat this operation for the
other doors. Check that the
system is activated when
the battery terminal is
disconnected and then
reconnected.
If the system does not work
properly, have it checked by your
dealer/retailer.