Character Activation Mode; Activation Character; Character Activation Laser Timeout; Character Deactivation Mode - Honeywell Vuquest 3330g User Manual

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the
received (see Deactivation Character
acter activation, then use Activation Character (following) to select the character you will send from the host to start scanning.
Default = Off.
* Off

Activation Character

This sets the character used to trigger scanning when using Character Activation Mode. On the
(Code Page 1252), page A-3, find the hex value that represents the character you want to use to trigger scanning. Scan
the following bar code, then use the
character. Scan Save

Character Activation Laser Timeout

You can set a timeout for the length of time the laser remains on and attempting to decode bar codes when using Character
Activation Mode. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting the timeout
(from 1-65535 milliseconds) by scanning digits from the

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scanning, you can also send a deactivation character
to stop scanning. Scan the following On bar code to use character deactivation, then use Deactivation Character (following) to
select the character you will send from the host to terminate scanning. Default = Off.
* Off
3 - 10
Character Activation Laser Timeout
on page 3-11), or a bar code is transmitted. Scan the following On bar code to use char-
Programming Chart
to finish.
Activation Character
Character Activation Laser
(page 3-10), the deactivation character is
to read the alphanumeric combination that represents that ASCII
Programming Chart, then scanning Save. Default = 5000 ms.
Timeout
On
ASCII Conversion Chart
On