Table of Contents
Advertisement
C a l i p e r P i s t o n R e m o v a l
DOT brake fluid will damage painted surfaces. If any fluid comes in contact with a painted surface (i.e. your frame) or printing on the brakes, wipe it off
immediately and clean it with isopropyl alcohol or water. Damage to painted and/or printed surfaces by DOT brake fluid is not covered under warranty.
1
Use a 2.5 mm hex wrench to install the pad retention bolt.
Insert the Guide pad spreader so that it snaps onto the pad retention
bolt.
2
Squeeze the brake lever to advance the pistons until they contact the
pad spreader.
3
Use a T25 TORX wrench to remove the banjo bolt.
N OT ICE
2.5 mm hex wrench
T25 TORX wrench
20 mm or 15 mm Thru Axle
Caliper Piston Removal
10
Advertisement
Table of Contents
