Child-Restraint Systems - Mazda 2002 Millenia Owner's Manual

J76Y.book Page 20 Wednesday, March 27, 2002 5:04 PM
Essential Safety Equipment
Child Restraint
M Rear Center Seat Child-Restraint
System Installation
Follow these instructions when using a
child-restraint system.
1. Secure the child-restraint system with a
lap belt. Adjust for a snug fit by pulling
on the loose end of the belt webbing.
2. If your child-restraint system requires
the use of a tether strap, hook the tether
strap by following the child-restraint
system manufacturer's instructions.
Cover
Anchor
bracket
2-20
Form No. 8Q47-EA-01F
Child-Restraint Tether Usage:
Using the tether to secure anything
but a child-restraint system is
dangerous. This could weaken or
damage the tether or tether anchor
and result in injury. Use the tether
and tether anchor only for a child-
restraint system.
M If You Must Use the Front Seat
for Children
If you cannot put all children in the rear
seat, at least put the smallest in the rear
and be sure the largest child up front uses
the shoulder belt over the shoulder.
Do not put rear-facing child-restraint
Open
systems on the front passenger's seat.
This seat is also not set up for tethered
child-restraint systems, put them in one of
the three rear seat positions set up with
tether anchors.
Don't allow anyone to sleep against the
Tether strap
right front door if you have an optional
side air bag, it could cause serious injuries
to an out of position occupant. As
children more often sleep in cars, it is
better to put them in the rear seat. If
installing the child-restraint system on the
front seat is unavoidable, follow these
instructions when using a front-facing
child-restraint system in the front
passenger's seat.
WARNING