Mazda 2002 Millenia Owner's Manual page 185

J76Y.book Page 13 Wednesday, March 27, 2002 5:04 PM
If it's at or near LOW, add enough coolant
to the coolant reservoir to provide
freezing and corrosion protection and to
bring the level to FULL.
CAUTION
Radiator coolant will damage paint.
Rinse it off quickly.
Do not overfill.
If new coolant is required frequently,
consult an Authorized Mazda Dealer.
M Changing Coolant
Change coolant according to Scheduled
Maintenance (page 8-3).
CAUTION
• Use only soft (demineralized) water
in the coolant mixture. Water that
contains minerals will cut down on
the coolant's effectiveness.
• Don't add only water. Always add a
proper coolant mixture.
• The engine has aluminum parts and
must be protected by an ethylene-
glycol-based coolant to prevent
corrosion and freezing.
• DO NOT USE alcohol or methanol
antifreeze. DO NOT MIX alcohol
or methanol with the coolant. This
could damage the cooling system.
• Don't use a solution that contains
more than 60 % antifreeze.
This would reduce effectiveness.
Form No. 8Q47-EA-01F
Owner Maintenance
For mixture percentage:
Protection
Antifreeze
solution
Above −16°C (3°F)
Above −26°C (−15°F)
Above −40°C (−40°F)
To change coolant
WARNING
Removing the Cooling System Cap:
Removing the cooling system cap or
drain plug while the engine is
running or hot is dangerous. This
might lead to cooling system and
engine damage and could result in
serious injury from escaping hot
coolant or steam. Turn off the engine
and wait until it's cool. Even then, be
very careful when removing the cap
or drain plug. Wrap a thick cloth
around it and slowly turn it
counterclockwise to the first stop.
Step back while the pressure escapes.
When you're sure all the pressure is
gone, press down on the cap — still
using a cloth — turn the cap, and
remove it.
Maintenance and Care
Volume
Water
35% 65%
45 55
55 45
8-13