Lincoln 1997 Continental Owner's Manual page 102

To determine if you have one of these systems,
depress the button on the HomeLink Transmitter
that you programmed. If the red light on the
HomeLink Transmitter flashes rapidly for 1-2
seconds, then remains on, your garage door opener
has a rolling code system.
Training a Garage Door Opener
Equipped with "Rolling Codes"
To train your "rolling code" garage door opener to
operate from your HomeLink Transmitter, follow
these steps:
1. Program your hand-held transmitter to the
HomeLink Transmitter by following the
procedures outlined in the "Programming"
section of these instructions. (If you already
completed this programming, proceed to the
next instruction.)
98
2. Train your garage door opener receiver to
recognize your HomeLink Transmitter. (Your
garage door opener receiver will learn to
recognize the HomeLink Transmitter by
following the same procedures used to train the
hand-held transmitter.)
Remove the cover panel from your garage door
opener receiver. (The receiver should be located
by the garage door opener motor.)
Locate the training button on the garage door
opener receiver. The exact location and color of
the button may vary by garage door opener
brand. If you have difficulty locating the training
button, reference your garage door opener
manual, or call 1-800-355-3515.
Press the training button on the garage door
opener receiver for 1-2 seconds.