Table of Contents
Advertisement
3. Attach the Zipper Foot.
Attach the left side of the presser foot pin to the presser
foot holder when sewing the right side of the zipper, and
right side of the presser foot pin to the holder when sewing
the left side of the zipper.
4. Stitch the left side of zipper from bottom to top.
5. Turn the fabric right side out stitch across the lower end
and right side of zipper.
6. Stop stitching with the needle down in the fabric when the
Zipper Foot reaches the zipper tab, about 5 cm (2") from
the top of the zipper.
7-10 mm
t
S
a
o
tItch
round the
1. Stop stitching before you reach the zipper tab.
2. Lower the needle into fabric.
3. Raise the presser foot and slide the zipper tab backwards
to clear the Zipper Foot.
4. Lower the presser foot and continue stitching.
5. Remove the basting stitches.
a. Zipper tab
Z
t
:
Ipper
ab
S
ewIng
QUILTING
A quilt consists of three layers:
The topper, batting, and backing fabric. The top layer is formed
by shaped pieces of fabrics joined together, creating the quilt
topper.
No. 0 Straight Stitch (Center Needle Position)
No. 198
Hand Look Quilting Stitch
Straight Stitch / Patchwork Quilting Foot
Quilting Bar
CAUTION
To prevent accidents, do not change the needle
position. Changing needle position could cause the
needle hit the presser foot, which could break the
needle or damage the machine.
J
oInIng the pIeceS of fabrIc
Join the pieces of fabric using Pattern No. 0 with a seam
allowance of 1/4 inch (6.3 mm)
Q
uIltIng
Sew three layers of material (topper, batting, backing). Use
quilting bar to sew successive rows. Insert quilting bar into the
hole of presser foot holder and set the spacing as desired.
h
l
Q
and
ook
uIltIng
Use invisible nylon sewing thread or very lightweight thread
that matches the fabric on top. Place thread that contrasts to
the color of the fabric on the bobbin. Set the upper tension to
maximum or near maximum. When you sew, bobbin thread will
pull to the top and give the appearance of a traditional hand
quilting stitch. Adjust the thread tension and stitch length as
desired for the look you want to achieve for your project.
30
S
(n
. 198)
tItch
o
Advertisement
Table of Contents
