Table of Contents
Advertisement
TO REGULATE LENGTH OF STITCH
The numerals on the stitch indicator
plate V denote the approximate num-
ber of stitches per inch.
To change
length
of stitch,
loosen
thumb screw X and move it to bottom
of slot. Move stitch regulating lever W
until its upper side is in line with the
number of the desired length of stitch.
Move thumb screw X until stitch regu-
lating plate (inside) touches lever W.
Tighten thumb screw X.
The machine will then make the indi-
cated number of stitches to the inch in
either a forward direction (lever W at
lowest position) or a reverse direction
(lever W at highest position).
TO REMOVE THE WORK
Stop machine with thread take-up lever
5, Fig..19 at its highest position. Raise
presser foot, draw the fabric back and
to the left, and sever the threads on
thread cutter T, Fig. 19. Place ends of
threads under presser foot, as shown in
Fig. 18.
Advertisement
Table of Contents
