Machine Control Functions; Tack Button With Led; Needle Position Up/Down Button With Led; Speed Control Button - Singer SE300 Instruction Manual

S u
ettIng p the

MACHINE CONTROL FUNCTIONS

t b led (a)
ack utton wIth
Press the tack button while sewing and your machine
sews a few Tack stitches and stops automatically. When
pressed while not sewing, machine will sew a tack and
stop automatically at the beginning of next sewing.
The LED light will turn on until tack stitch has completed.
n p u /d
eedle oSItIon p
(b)
Press this button to move the needle up or down. The
setting of the needle stop position is changed at the same
time. When needle position is setted to down, the LED will turn
on.
You can also tap the foot control to raise or lower the needle.
S c b
peed ontrol utton
The Speed Control Buttons allow you to incrementally increase
or decrease the sewing speed. When either button (C or D)
is pressed, a pop-up message appears showing the range of
speed settings available.
NOTE:
When the foot controller is connected, these buttons decrease
and increase the speed limit.
t c b
hread utter utton wIth
Press this button after sewing to cut the upper and bobbin
threads.
The LED will turn on and cut both threads automatically.
To cut before the needle moves to the start position of
the next stitch, press the Thread Cutter button while
sewing. The LEDs (A & E) will be lit and the machine
will cut the threads after the stitch or sequence has
completed.
CAUTION:
1. Do not press this button when there is no fabric under the
presser foot or no need to cut the threads. The thread may
tangle, resulting in damage.
2. Do not use this button when cutting thread thicker than #30,
nylon thread or other speciality threads.
In this case, use the thread cutter (H).
3. Do not use the Thread Cutter button when sewing with a twin
needle or a hemstitching (wing) needle.
S /S b (f)
tart top utton
The machine will start running when Start/Stop button is
pressed and will stop when pressed the second time. The
machine will rotate slowly at start of sewing.
NOTE:
1. When the foot controller is connected, Start/Stop button will
be deactivated.
2. Bobbin winding function is independent from this button. (See
page 17)
m
achIne
b led
own utton wIth
(c, d)
led (e)
r S b
everSe tItch utton
The machine will sew in reverse while this button is pressed.
When released, machine will sew forward.
p f l
reSSer oot Ifter
The presser foot is raised or lowered by this lever.
If you are sewing on heavy fabric or several
layers of fabric, the presser foot can be raised higher to make
it easier to place the fabric underneath the presser foot.
NOTE:
Machine will not start when the presser foot is raised. (Except
for bobbin winding)
11
(g)
(h)