Table of Contents
Advertisement
If desired, you can change the TAS automatic
engagement feature so that the system will not come on
automatically when the engine
is
started. To do so:
1. Park the vehicle with the ignition off and the
2. Turn the ignition to RUN; do not start the engine.
3. Apply the brake pedal, press the accelerator
pedal to the floor and then press the TAS on/off
button and hold it down for at least six seconds.
transmission in PARK (P).
4. Release the TAS button and both pedals.
5. Turn off the ignition and wait a few seconds.
The next time you start your vehicle, the TAS will not
automatically come on. You can restore the automatic
feature by using the same procedure. Whether the TAS
is set to come on automatically or not, you can always
turn the system on or off by pressing the TAS on/off
button.
Manual Selectable Ride
The main function of this system is to provide superior
ride comfort while trailering or fully loaded, as well
as for unloaded driving. This system also helps
to provide:
Improved trailering stability
This button is located on
the center of the
instrument panel near the
radio. Press it to activate
the selectable ride
setting as desired. An
indicator light near
the button will illuminate
whenever the system
is active.
It is recommended to use this system as follows:
*
For optimum ride comfort in an unloaded vehicle
the button should be out and the indicator light
will not be illuminated. This switch position indicates
NORMAL levels of ride control or damping.
0
For optimum ride comfort when trailering, fully
loaded, driving off-road, or when personal
preferences demand more control the button should
be pressed in with the indicator light illuminated.
This switch position indicates FIRM levels of
ride control or damping.
The following guide can also be used to help determine
the best setting.
Improved handling response when trailering or fully
loaded
4-1 1
Advertisement
Table of Contents
