Table of Contents
Advertisement
Turn and Lane Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when you signal
a turn, check for burned-out bulbs or a blown fuse
See Fuses and
Circuit
Breakers on
page
5-1
11.
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
Turn Signal On Chime
When the turn is finished, the lever will return'
If your turn signal is left on for more than
3/4 of a mile
automatically.
(1:2 km), a chime will sound at each flash of the
turn signal. To turn off the chime, move the turn signal
An arrow on the instrument
lever to the off position.
panel cluster will flash in
the direction of the
Headlamp High/Low Beam Changer
turn or lane change.
To change the headlamps from low to high beam, push
the lever toward the instrument panel. To return the
low-beam headlamps, pull the multifunction lever toward
you. Then release it.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by itself
when you release it.
If you move the lever all the way up or down, and the
arrow flashes at twice the normal rate, a signal bulb may
be burned out and other drivers may not see your
turn signal.
When the high beams are
on, this light on the
instrument panel cluster
also
will be on.
3-8
Advertisement
Table of Contents
