Advertisement
Using the new functions
Synchronized recording and auto
track increment
Press and hold down the SYNC REC key for about one second.
The unit displays the Sound Level screen. When the unit detects
an audio signal at a sound level equal to or higher than the thresh-
old specified in this screen, synchronized recording or the auto
cue function is enabled.
The recording stops if the sound level falls below and remains
lower than the threshold specified by the SOUND LEVEL parame-
ter for longer than the duration specified by the SYNC STOP
parameter.
The ATRK (auto track) INTERVAL parameter is the duration of a
silence required to execute the auto track increment function.
Note
If you are using the synchronized recording and auto track incre-
ment functions at the same time, set the SYNC STOP value
longer than the ATRK INTERVAL so that the recording will not be
stopped by an audio signal level that is lower than the threshold.
Figure 9.1: Setting the sound level threshold
Setting the SOUND LEVEL parameter
1
Use the F1 or F2 key (cursor key) to select SOUND LEVEL .
2
Rotate the wheel to select a sound level from the following
options:
–72dB, –66dB, –60dB, –54dB, –48dB, –42dB,
–36dB, –30dB, –24dB, DD (digital detect, equivalent to
–54dB)
3
Press ENTER to confirm your selection.
Note
If you select an option that is -48 dB or lower in DSD mode, the
level will automatically be set to -48dB internally.
Setting the ATRK INTERVAL parameter
1
Use the F1 or F2 key (cursor key) to select ATRK INTERVAL .
2
Rotate the wheel to select an interval in the range of 1 second
through 6 seconds, with the default value set to 2 seconds.
3
Press ENTER to confirm your selection.
2
TASCAM DV-RA1000 Ver1.01
DV-RA1000 Version 1.01 Supplemental Manual
Setting the SYNC STOP parameter
1
Use the F1 or F2 key (cursor key) to select SYNC STOP .
2
Rotate the wheel to select a time in the range of 5 seconds
through 60 seconds (in 5 second steps), with the default
value set to 5 seconds. If you do not want recording to stop if
a silence is detected, select INF .
3
Press ENTER to confirm your selection.
Auto track increment
You can select Level mode or Time mode for the Auto track
increment.
Level mode functions in the same way as with version 1.00,
except that you can now change the position of a track increment
via the delay value. Time mode automatically increments the
tracks according to the specified time interval during recording.
Auto track increment recording in Level mode
[Setting the MODE parameter]
1
Use the F1 to F4 key (cursor key) or the wheel on the virtual
front panel screen to select ATRK .
2
Press and hold down ATRK for more than one second to open
the Auto Track screen.
3
Use the F1 or F2 key (cursor key) to select MODE .
4
Rotate the wheel to set the MODE parameter to LEVEL .
[Setting the DELAY parameter]
1
Use the F1 or F2 key (cursor key) to select DELAY .
2
Rotate the wheel to set the delay time in the range of +1.7
seconds through –1.7 seconds, with the default value set to 0
seconds.
3
After you set the MODE and DELAY parameters, press
ENTER to confirm your settings.
After synchronized recording or manual recording starts, the
tracks will be incremented automatically by the level changes of
the audio signal.
Figure 9.2 Auto track Level mode screen
Advertisement
