Table of Contents
Advertisement
CN9900/CN9950 Front View
No.
Component
1
PC/KVM Port
2
KVM Audio
Ports
3
CPU COM
(RS-232 DTE)
Port
4
Local Console
COM (RS-232
DCE) Port
5
KVM USB
Type-B Port
6
Laptop USB
Console (LUC)
Port
7
Reset button
8
Power LED
Use the DisplayPort cable provided to connect the PC / server
to the CN9900/9950 through this port.
Connect the audio of the PC / server to this port for audio
signal transmission.
Connect a serial data communication equipment device (e.g. a
modem or PC) to this port. See page 24 for details.
Connect a serial data terminal equipment device (e.g. a PC or
touch panel) to this port. See page 24 for details.
Use the USB cable (USB Type-A to USB Type-B) provided to
connect the PC / server to this port for keyboard and mouse
signal transmission.
For laptop local access (See Local Access, page 115),
connect the laptop to this port using the USB Type-A to USB
Mini-B cable provided.
Make sure the mode of USB IO Settings (see USB IO
Settings, page 68) is set to LUC.
If the mode of USB IO Settings is set to Virtual Media, this port
will not work.
Press the Reset button for more than three (3) seconds to
revert to factory settings.
Lights Green when the CN9000 is powered up.
Chapter 1. Introduction
Description
13
Advertisement
Table of Contents
