Table of Contents
Advertisement
INTRODUCTION
Screen Saver Mode
For security reasons, it is sometimes required to hide the status indication (LCD and LED display) from a
potential intruder. If the Screen Saver option is enabled by the installer, then if no key is pressed for more than
30 seconds, the display will read "WP Panel" and the LEDs will stop indicating any status. Pressing any key will
resume the normal status display. Pressing the Fire or Emergency keys will also initiate the Fire or Emergency
alarm.
If configured by the installer for additional security, the system will ask you to enter your user code as well
before resuming the normal display.
When partition is enabled, the installer can configure the system so that if no key is pressed during more than 30
seconds the date and time will appear on the display.
Proximity Tags
Your system responds to valid proximity tags enrolled to the system. The proximity tag enables you to perform a
variety of functions without entering user code, for example, arming, disarming, reading the event log, etc.
Whenever the user code is required, you can simply present a valid proximity tag and perform the desired
operation without the need to key-in your user code.
When the system is disarmed, after presenting a valid proximity tag to the control panel, the message "<OK> for
AWAY" is displayed. Now you can press the
button to immediately arm the control panel, or wait for 3
second for system automatic AWAY arming (the message "Please exit now" will be displayed). Presenting the
proximity tag once again will DISARM the system.
Instead of pressing the
button (see above), you can press the
button once / twice (the
message "<OK> for HOME" / "<OK> for disarm" is displayed, accordingly) and then press the press
button for HOME arming / disarming.
Note: For UL Listed product, the proximity feature may only be used to arm or disarm the system.
Users and Codes
As a master User (User No.1) you will need a 4-digit security code to master the system (code 0000 is not
allowed).You can also authorize 7 other persons (WP Panel) / 47 other persons (WP Panel) to use the system
by providing them with their own security codes (see Chapter 6, B.4 Programming User Codes). Security codes
are used mainly to arm and disarm the system or to access information that is restricted only to authorized users
(see Chapter 6, B.4 Programming User Codes).
Moreover, you can obtain up to 8 (WP Panel) / 32 (WP Panel) multi-function portable keyfob transmitters that
will allow you and the other users to easily arm, disarm and control the system without accessing the panel,
including from outside the premises (see Chapters 2 and 6, B.7 Add / Delete Keyfob Transmitters).
The Duress Code enables you to disarm the system using a special code that sends a silent alarm to the
monitoring station (See chapter 2).
8
D-306232 WP8010/WP8030 V18 DSC EN USER
Advertisement
Table of Contents
