Caster Assembly - DeWalt DXV06P Instruction Manual

ENGLISH
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
UNPACKING & SETUP SUMMARY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may
have been shipped in the tank.
2. Attach accessories following the instructions
in this manual.
3. Before replacing power head, refer to this
manual to ensure you have the proper lter
installed for the cleaning operation.
4. Replace power head, and apply pressure
with thumb to each latch until it snaps
tightly in place. Make sure all lid latches are
clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach the extension wands to the end of the
hose. Apply slight pressure until tting is tight.
7. Attach one of the cleaning accessories
(depending on the cleaning requirements) to
the extension wands. Twist slightly to tighten
the connection.
8. Plug the cord into the wall outlet. The vacuum
is ready for use.
9. To reduce the risk of injury from accidental
starting, always shut off vacuum and
disconnect the power plug from the wall
outlet before installing any part or
cleaning accessory.
WARNING:
To reduce the risk of re or explosion, do not
operate this vac in areas with ammable gases,
vapors or explosive dust in the air. Flammable
gases or vapors include but are not limited to:
lighter uid, solvent-type cleaners, oil-based
paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not
limited to: coal, magnesium, aluminum, and
grain or gun powder. Do not vacuum
explosive dust, ammable or combustible
liquids or hot ashes. Do not use this vac as
a sprayer for any ammable or combustible
liquid. To reduce the risk of health hazards
from vapors or dusts, do not vacuum
toxic materials.
WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes,
which can result in severe eye injury. Always
wear safety goggles complying with ANSI
Z87.1 (or in Canada, CSA Z94.3) before
starting operation.

CASTER ASSEMBLY

1. Invert dust tank, take the casters to align
the tank bottom sinking place. Secure with
screws provided.
2. Return dust tank assembly upright.
WARNING:
To reduce the risk of re or explosion, do not
operate this vac in areas with ammable gases,
vapors or explosive dust in the air. Flammable
gases or vapors include but are not limited to:
lighter uid, solvent-type cleaners, oil-based
paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not
limited to: coal, magnesium, aluminum, and
grain or gun powder. Do not vacuum
explosive dust, ammable or combustible
liquids or hot ashes. Do not use this vac as
a sprayer for any ammable or combustible
liquid. To reduce the risk of health hazards
from vapors or dusts, do not vacuum
toxic materials.
WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes,
which can result in severe eye injury. Always
wear safety goggles complying with ANSI
Z87.1(or in Canada, CSA Z94.3) before
starting operation.
4