Product Specifications; Caster Assembly - DeWalt DXV09PA Instruction Manual

WARNING:
Always wear proper personal
hearing protection that conforms to
ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this
product may contribute to hearing loss.
WARNING:
Always use safety goggles.
Everyday eyeglasses are NOT safety goggles. Also
use face or dust mask if area of operation is dusty.
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection(CAN/CSA Z94.3),
• ANSI S12.6(S3.19)hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
WARNING:
This product can expose you
to chemicals including lead, which is known to the
State of California to cause cancer, birth defects or
other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
To reduce the exposure to these chemicals, wear
approved safety equipment such as dust masks that
are specially designed to filter out microscopic particles.
WARNING:
• TO REDUCE THE RISK OF INJURY, USERS MUST
READ INSTRUCTION MANUAL. DO NOT RUN
UNATTENDED. DO NOT PICK UP FLAMMABLE,
COMBUSTIBLE OR HOT MATERIALS. DO NOT
USE AROUND EXPLOSIVE DUST, LIQUIDS OR
VAPORS. ELECTRICAL DEVICES PRODUCE
ARCS OR SPARKS WHICH CAN CAUSE FIRE
OR EXPLOSION. DO NOT USE AT FILLING
STATIONS OR ANYWHERE GASOLINE IS
STORED OR DISPENSED. DO NOT VACUUM
TOXIC OR CARCINOGENIC MATERIALS OR
OTHER HEALTH ENDANGERING MATERIALS
SUCH AS ASBESTOS OR PESTICIDES.
ALWAYS USE PROPER EYE AND RESPIRATORY
PROTECTION. TO REDUCE THE RISK OF
ELECTRICAL SHOCK, DO NOT EXPOSE TO
RAIN. STORE INDOORS. WHEN SERVICING,
USE ONLY IDENTICAL REPLACEMENT PARTS.
DO NOT TO BE USED AS A STEP STOOL.

PRODUCT SPECIFICATIONS

Model DXV09PA
Tank Capacity
9 Gallon
Power
120 V / 60 Hz / 10 A
Motor Single Stage
Hose
1-7/8 in. x 7 ft.
Power cord
SJTW18AWG / 10 ft. Length
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
UNPACKING & SET-UP SUMMARY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may
have been shipped in the tank.
2. Attach heavy-duty rubberized casters
following the instructions in this manual.
3. Before replacing power head, refer to this
manual to ensure you have the proper lter
installed for the cleaning operation.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in
place. Make sure all lid latches are
clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach the extension wands to the end of the
hose. Apply slight pressure until tting is tight.
7. Attach one of the cleaning accessories
(depending on the cleaning requirements) to
the extension wands. Twist slightly to tighten
the connection.
8. Plug the cord into the wall outlet. The vacuum
is ready for use.
9. To reduce the risk of injury from accidental
starting, always shut off vacuum and disconnect
the power plug from the wall outlet before
installing any part or cleaning accessory.

CASTER ASSEMBLY

1. Invert dust tank, take the casters to align the
tank bottom sinking place. Secure with
screws provided.
2. Return dust tank assembly upright.
ACCESSORY BAG HOLDER BRACKET
ASSEMBLY
Attach 2 accessory bag holder brackets to tank
with 4 self-tapping screws provided.
(See Illustration F.1）
3
ENGLISH