Table of Contents
Advertisement
Knowing your Router
Rear Panel
(5) Reset Button
The reset button is used in the rare event that the Router functions
improperly. Resetting the Router will restore the Router's normal
operation while maintaining the programmed settings. You can also
restore the factory default settings by using the reset button. Use the
restore option in instances where you may have forgotten your custom
password.
a.
Using the Reset Button to Reset the Router
Push and release the Reset button. The lights on the Router
will momentarily flash. The Power/Ready light will begin to
blink. When the Power/Ready light becomes solid again, the
reset is complete.
b.
Using the Reset Button to Restore the Factory Defaults
Press and hold the Reset button for five seconds then
release it. The lights on the Router will momentarily flash.
The Power/Ready light will begin to blink. When the Power/
Ready light becomes solid again, the restore is complete.
(6) Modem Port
This port is for connection to your cable or DSL modem. Use the cable
that was provided with the modem to connect the modem to this port.
We recommend you use the included, high-quality networking cable,
rather than another cable, which may not work properly.
(7) Computer (LAN) Ports
Connect your computers to these ports. These ports are RJ45, 10/100
auto-negotiation, auto-uplinking ports for standard UTP category 5
or 6 Ethernet cable. The ports are labeled 1 through 4. These ports
correspond to the numbered LEDs on the front of the Router.
(8) Power Jack
Connect the included DC 3.3V /1.5A power supply to this jack.
(5)
(6)
8 8
(7)
(8)
Advertisement
Table of Contents
