Enter Password - MSI MS-6137 User Manual

Micro-atx wh1 mainboard

Hide thumbs Also See for MS-6137:

Table of Contents

CHAPTER 3

You can set either supervisor or user password, or both of them. The

differences are:

Supervisor password : can enter and change the options of the setup

User password

ENTER PASSWORD:

Type the password, up to eight characters in length, and press <Enter>. The

password typed now will clear any previously entered password from CMOS

memory. You will be asked to confirm the password. Type the password again

and press <Enter>. You may also press <Esc> to abort the selection and not

enter a password.

To disable a password, just press <Enter> when you are prompted to enter the

password. A message will confirm the password will be disabled. Once the

password is disabled, the system will boot and you can enter Setup freely.

PASSWORD DISABLED.

When a password has been enabled, you will be prompted to enter it every

time you try to enter Setup. This prevents an unauthorized person from chang-

ing any part of your system configuration.

Additionally, when a password is enabled, you can also require the BIOS to

request a password every time your system is rebooted. This would prevent

unauthorized use of your computer.

menus.

Can only enter but do not have the right to change

the options of the setup menus. When you select

this function, the following message will appear at

the center of the screen to assist you in creating a

password.

AWARD

3-32

BIOS SETUP

Table of Contents

Ms-6137 v3