Directives And Declarations; Electromagnetic Compatibility, Industrial And Residential Areas - Siemens SIMATIC IPC227G Operating Instructions Manual

Technical specifications

7.2 Directives and declarations

Specific conditions of use (for ATEX)
• The modules shall be installed in a suitable enclosure providing a degree of protection of
at least IP54 according to EN 60079-7, taking into account the environmental conditions
under which the equipment will be used.
• Provisions shall be made to prevent the rated voltage from being exceeded by transient
disturbances of more than 119 V.
Specific conditions of use (for IECEx)
• The equipment shall only be used in an area of not more than pollution degree 2, as
defined in IEC 60664-1.
• The modules shall be installed in a suitable enclosure providing a degree of protection of
at least IP54 according to IEC 60079-7, taking into account the environmental conditions
under which the equipment will be used.
• Provisions shall be made to prevent the rated voltage from being exceeded by transient
disturbances of more than 119 V.
Switch:
SW1 On/Off switch - will not be used during operational maintenance
The device has to be used in pollution degree 2 environment only.
Use copper supply wires with a diameter of at least 0.75 mm
WEEE label (European Union)
Disposal instructions, observe the local regulations and the section "Recycling and disposal
(Page 56) ".
7.2 Directives and declarations
7.2.1

Electromagnetic compatibility, Industrial and Residential Areas

Electromagnetic compatibility
This product meets the requirements of EC Directive 2014/30/EU "Electromagnetic
Compatibility".
The device is designed for the following areas of application corresponding to the CE
marking:
Scope of application
Industrial area
60
Interference emission
EN 61000-6-3 +A1, CAN/CSA-CISPR 22:10
(= AWG18).
2
Requirements for
Immunity to interference
EN 61000-6-2, NAMUR NE 21
Operating Instructions, 06/2021, A5E50059933-AA
SIMATIC IPC227G