Chevrolet 2003 Silverado 1500 Pickup Owner's Manual page 228

DlSP (Display): Push this knob to switch the display
between radio station frequency and time. Time display
is available with the ignition turned off.
For RDS, push this knob to change what appears on
the display while using RDS. The display options
are station name, RDS station frequency, PTY and the
name of the program (if available).
For XMTM (USA only, if your radio is equipped with
XMTM Satellite Radio Service), push this knob while in
XM mode to retrieve various pieces of information
related to the current song or channel. By pressing and
releasing this knob, you may retrieve four different
categories of information: Artist, Song Title, Category or
PTY, Channel NumberKhannel Name.
For DAB (Canada only, if your radio is equipped with
DAB), pushing this knob switches the display between
channel name and PTY name.
To change the default on the display, push this knob
until you see the display you want, then hold the knob
for two seconds. The radio will produce one beep
and selected display will now be the default.
Finding a Station
BAND: Press this button to switch between AM, FM,
FM2, or XMI, XM2 (USA only, if your radio is equipped
with XMTM Satellite Radio Service) or DABI, DAB2
(Canada only, if your radio is equipped with DAB). The
display will show your selection.
TUNE: Turn this knob to choose radio stations.
For DAB (Canada only, if your radio is equipped with
DAB), the TUNE knob allows you to navigate the DAB
frequency range. Turning this knob will tune up or tune
down the range. The radio will display the ietter
L
with a
number next to it (1 through 23). Each L number refers to
a frequency and there can be multiple stations contained
in one frequency. It may also take a few seconds, once
you have tuned to a frequency, for that frequency to
gather all of the stations. Depending on how many
stations are within a frequency, with every tune up or
down, you may be tuning to another station or to another
frequency. The display will show your selections.
4
SEEK
b
: Press the right or the left arrow to seek
to the next or to the previous station and stay there.
The radio will seek only to stations that are in the
selected band and only to those with a strong signal.
4
SCAN
b
: Press and hold one of the arrows for
more than two seconds. The radio will produce one beep.
The radio will scan to a station, play for a few seconds,
then go on to the next station. SCAN will be displayed.
Press one of the arrows again to stop scanning.
The radio will scan only to stations that are in the selected
band and only to those with a strong signal.
3-73