Husqvarna 130C Operator's Manual page 14

Grass trimming with a trimmer head
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line
into the grass.
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk
of damage to plants.
4. Use 80 % throttle when you cut grass near
objects.
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
14
3. Move the product from side to side when you cut
grass. Use full speed.
To sweep the grass
The airflow from the rotating trimmer line can be
used to remove cut grass from an area.
1. Hold the trimmer head and the trimmer line
parallel to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and
sweep the grass.
WARNING:
cover each time you assemble new
trimmer line to prevent unbalance and
vibrations in the handles. Also do a
check of the other parts of the trimmer
head and clean it if necessary.
To extend the trimmer line
• When the trimmer line becomes short during
operation, tap the trimmer head on a hard, flat
surface to extend more trimmer line. You must
operate the product at full speed to get the best
result.
Clean the trimmer head
1687 - 003 - 22.09.2021