Husqvarna 130C Operator's Manual page 12

8. Move the product 3 m/10 ft or more away from
the refueling area and fuel source before you
start the engine.
Note:
To see where the fuel tank is on your
Introduction on page 2 .
product, refer to
To do before you operate the
product
WARNING:
without a guard or a guard that is
defective.
• Examine the work area to make sure that you
know the type of terrain. Examine the slope of
the ground and if there are obstacles such as
stones, branches and ditches.
• Do an inspection of the product.
• Do the safety inspections, maintenance and
service that are given in this manual.
• Make sure that all covers, the cutting attachment
guard and the trimmer head are correctly
attached and not damaged. Replace damaged
parts.
To start a cold engine
1. Push the air purge bulb 10 times.
12
Do not use the product
2. Put the choke control in the full choke position.
3. Hold the product on the ground with your hand.
Do not step on the product.
WARNING:
throttle trigger while you start the
engine.
4. Pull the starter rope handle 3 times with force.
CAUTION:
starter rope until it stops. Do not let
go of the starter rope when it is fully
extended. Release the starter rope
slowly. Failure to obey these
instructions can cause damage to the
engine.
Do not pull the
Do not pull the
1687 - 003 - 22.09.2021