Operation - Husqvarna 130C Operator's Manual

To attach the loop handle (130L)
1. Attach the loop handle onto the shaft between
the arrows.
2. Move the spacer into the slot of the loop handle.
3. Install the nut, the knob and the bolt. Do not
tighten the bolt fully.
4. Adjust the product to a correct position.
5. Tighten the bolt.
To attach the loop handle (130C)
1. Attach the loop handle to the shaft in compliance
with the illustration and tighten.
2. Make sure that the loop handle attaches between
the arrows on the shaft.
To attach the cutting attachment guard and
the trimmer head (straight shaft)
1. Attach the cutting attachment guard (A) to the
shaft with the bolt (L).
2. Attach the drive disc (B) to the output shaft.
3. Turn the output shaft until the hole in the drive
disc aligns with the hole in the gear housing.
Fuel
This product has a two-stroke engine.
10
4. Put a small screwdriver (C) in the hole to lock the
shaft.
5. Turn the trimmer head (H) counterclockwise to
tighten the trimmer head to the gearbox. (Left
hand threads.)
To attach the cutting attachment guard and
trimmer head (curved shaft)
1. Attach the guard. Tighten the nut.
2. Attach the dust cup on the shaft.
3. Hold the dust cup with an adjustable wrench to
make sure the shaft does not turn.
4. Attach the trimmer head to the shaft. Turn the
trimmer head clockwise.

Operation

CAUTION:
result in engine damage. Use a mixture
of gasoline and two-stroke oil.
L
A
A
H
Incorrect type of fuel can
1687 - 003 - 22.09.2021
B
C