Table of Contents
Advertisement
Automatic Compass Calibration
-
The compass is self
calibrating, which eliminates the
need to manually set the compass. When the vehicle is
new, the calibration process may not be complete. In
these cases "CAL" will be displayed, and all segments
of the compass will be illuminated where the compass
reading is normally displayed.
All Segments Illuminated
To calibrate the compass, in an area free from large
metal objects, make two or three 360 _ turns. The
calibration symbol will turn off and the compass reading
will be displayed.
Manual Compass Calibration
If the compass appears erratic and the calibration
symbol does not appear, you must manually put the
compass into the calibration mode.
Turn the ignition on and cycle the DIC to the
Compass/Temperature mode. Press the RESET button
for at least 10 seconds until the calibration symbol
appears and all segments of the compass display are
illuminated. Release the button and complete
three 360 _ turns in an area free from large metal objects.
The calibration symbol will turn off and the compass
reading will be displayed.
Error Displays
D
An error of the vehicle's speed sensor or fuel sender
-
-
will cause
E
to be displayed.
D
In the absence of vehicle communications, a double
--
dash "
" is displayed.
If one of these error messages appear, see your dealer.
2-83
Advertisement
Table of Contents
