Loading The Batteries - Pioneer VSX-1024 Operating Instructions Manual

1
1
CD, NETWORK, iPod/USB, MHL, and BT (ADPT) will be
random playback.
11 POP UP
Popup menu will be displayed for BD.
CD, NETWORK, iPod/USB, MHL, and BT (ADPT) will be
repeat playback.
12
Other component controls
There are other buttons that can be accessed after
is pressed.
SB CH (VSX-1024 only) – Press to select ON, AUTO or OFF
the surround back channel (page 38).
CH SEL – Press repeatedly to select a channel, then use
CH LEVEL +/– to adjust the level (page
CH LEVEL +/– – Use to adjust the channel level.
BASS +/–, TRE +/– – Use to adjust Bass or Treble.
• These controls are disabled when the listening mode is
set to DIRECT or PURE DIRECT.
• When the front speaker is set at SMALL in the Speaker
Setting (or automatically via the Auto MCACC setup)
and the X.Over is set above 150 Hz, the subwoofer
channel level will be adjusted by pressing
(page 54).
DIMMER – Dims or brightens the display. The
brightness can be controlled in four steps.
During ECO mode, the brightness switches between 2
levels. If the dimmest level is selected, DIMMER will be
shown on the display. (Mode other than ECO: 4 levels, ECO
mode: 2 levels)
SP-A/B – See Switching the speaker terminal on page
STATUS – Switches the display of this unit. The
listening mode, input format, sound volume, Speaker
System (VSX-1024) setting or input name can be checked
by selecting an input source.
The Input format may or may not be displayed, depending
on the input source you have selected.
The Speaker System setting may or may not be displayed,
depending on the input source you have selected.
13
SOURCE
Press to turn on/off the power to the Pioneer device
connected to the receiver.
14 ECO
Switches between ECO Mode 1/ECO Mode 2. When ECO
Mode is turned ON, the display will go dark
15 TV
buttons
Operates a TV. When operating other manufacturer's TV,
setup as follows.
– Use to turn on/off the power of the TV.

RECEIVER INPUT – Use to select the TV input signal.
CH +/– – Use to select channels.
VOL +/– – Use to adjust the volume on your TV.
While holding down
buttons (listed in the table below) for component you want to
54).
control for about five seconds.
This may not operate depending on the TV.
Default setting: Pioneer
TV preset
Input Function
button
RECEIVER CTRL
BASS +/–
BD
GAME
HDMI
DVD
SAT
MHL
18. iPod
CD
BT/ADPT
TUNER
TV
NET
16 MUTE
Mutes/unmutes the sound.
17 VOLUME +/–
Use to set the listening volume.
(page 38).
TV  button, press the input function
TV Brand
Pioneer
Panasonic
Sony
Sharp
Toshiba
Mitsubishi
Philips/AOC/TPV
Vizio
Samsung
LG Electric
Skyworth
Hisense
TCL
12
Controls and displays
18 +Fav
Press while a song is being played back or stopped. The
selected song is then registered in the Favorites folder
(page 45).
19 DISP
Each entry source information will be displayed.
AUDIO CLR
20
Songs and preset radio stations registered will be deleted
when NETWORK is selected.
Audio will be switched when set to other than NETWORK.

Loading the batteries

The batteries included with the unit are to check initial
operations; they may not last over a long period. We
recommend using alkaline batteries that have a longer life.
WARNING
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or catch
fire. It can also reduce the life or performance of batteries.
CAUTION
• Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
Never use new and old batteries together.
-
Insert the plus and minus sides of the batteries properly
-
according to the marks in the battery case.
Batteries with the same shape may have different
-
voltages. Do not use different batteries together.
When disposing of used batteries, please comply with
-
governmental regulations or environmental public
institution's rules that apply in your country/area.
- When inserting the batteries, make sure not to damage
the springs on the battery's (–) terminals. This can cause
batteries to leak or overheat.
4
9
61