Low Power Mode - Ricoh MT-C4 Manual

The machine enters low power mode when the energy
saver timer runs out after the last job.
The energy saver timer is controlled by User Tools: Timer
settings.
When the machine enters low power mode, the fusing
temperature is lowered to the prescribed temperature
(below the machine ready temperature).
The machine recovers to the ready condition if one of the
following occurs:
The Energy Saver key is pressed
An original is placed in the ADF
The ADF is lifted
The user touches the operation panel
The front door is opened or closed
The recovery time depends on the model and the region.
MT-C4-a/b/d: 10 seconds
MT-C4e: 30 seconds
Slide 77
No additional notes
Energy Saver Modes

Low Power Mode

77
MT-C4 Training