Cadillac 2010 Escalade Owner's Manual page 205

The headlamp stalk is moved forward to
the high-beam position. See Headlamp High/
Low-Beam Changer on page 4 5.
When either of these conditions occur, the
®
IntelliBeam feature will be disabled and the
®
IntelliBeam light in the mirror will turn off until the
high-beam stalk is returned to the neutral position.
®
If IntelliBeam was using low-beams prior to this
®
action, the IntelliBeam
disabled until the stalk is returned to the neutral
position.
The exterior lamp control is turned to any setting
except AUTO.
When this occurs, IntelliBeam
until the control is turned back to the AUTO
position.
®
The IntelliBeam system is turned off at the inside
rearview mirror.
feature will be temporarily
®
will be disabled
®
IntelliBeam may not turn off the high-beams if the
system cannot detect other vehicle's lamps because of
any of the following:
The others vehicle's lamp(s) are missing,
damaged, obstructed from view or otherwise
undetected.
The other vehicle's lamp(s) are covered with dirt,
snow and/or road spray.
The other vehicle's lamp(s) cannot be detected
due to dense exhaust, smoke, fog, snow, road
spray, mist or other airborne obstructions.
Your vehicle's windshield is dirty, cracked or
obstructed by something that blocks the view of
the IntelliBeam light sensor.
Your vehicle's windshield is covered with ice, dirt,
haze or other obstructions.
Your vehicle is loaded such that the front end of
the vehicle points upward, causing the IntelliBeam
sensor to aim high and not detect headlamps and
taillamps.
You are driving on winding or hilly roads.
You may need to manually disable or cancel the
high-beam headlamps by turning the low-beam
headlamps on, if any of the above conditions exist.
4-13