Cadillac 2008 XLR Owner's Manual page 288

Close Guidance, Close Guidance Screen, Close
Guide, Close Guide Screen: These commands
will cause the system to close the Guidance Appearance
menu if a destination has been set.
Arrow Guidance, Arrow Guide, Change To Arrow
Guidance, Change To Arrow Guide: These
commands will cause the system to change to Arrow
Guidance screen view in the Guidance Menu if a
destination has been set.
Turn List Guidance, Turn List Guide, Change to
Turn List Guidance, Change to Turn List Guide:
These commands will cause the system to change to
Turn List Guidance screen view in the Guidance Menu
if a destination has been set.
Entire Route, Entire Route Map, Route Overview:
These commands will cause the system to display the
entire route if a destination has been set.
Reroute: This command will cause the system to
generate an alternate route to a set destination while on
a planned route.
Detour, Detour Entire Route: These commands will
cause the system to activate the detour feature
when driving a planned route.
4-80
Delete Destination, Cancel Destination: These
commands will cancel a destination if one has been set.
Next Waypoint Map: This command will cause the
system to display the map view of the next waypoint
location if one has been set.
First Waypoint Map: This command will cause the
system to display the map view of the first waypoint
location if one has been set.
Second Waypoint Map: This command will cause the
system to display the map view of the second waypoint
location if more than one waypoint has been set.
Third Waypoint Map: This command will cause the
system to display the map view of the third waypoint
location if more than two waypoints have been set.
Fourth Waypoint Map: This command will cause the
system to display the map view of the fourth waypoint
location if more than three waypoints have been set.
Fifth Waypoint Map: This command will cause
the system to display the map view of the fifth waypoint
location if more than four waypoints have been set.
Destination Map: This command will cause the system
to display the map view of the final destination location
if one has been set.