Cadillac 2008 XLR Owner's Manual page 161

You can switch from English to metric units through the
Driver Information Center (DIC). See DIC Operation
and Displays on page 3-60 for more information.
The air conditioning system removes moisture from the
air, so you may sometimes notice a small amount of
water dripping underneath your vehicle while idling
or after turning off the engine. This is normal.
Do not cover the solar sensor located in the center of
the instrument panel, near the windshield. For more
information on the solar sensor, see "Sensors" later in
this section.
Manual Operation
w x
PWR (Power/Temperature): Press the PWR
button on the left side of the climate control panel to turn
the entire climate control system on or off. Press the
up or down arrow on the switch to manually increase or
decrease the temperature inside the vehicle.
Press the PWR button on the right side of the climate
control panel to turn the passenger's climate control
system on or off. Press the up or down arrow on
the switch to manually increase or decrease the
temperature for the passenger.
If the passenger's PWR button is off, the driver's
temperature switch controls the temperature for the
entire vehicle.
«9ª
(Fan): Press this switch to increase or
decrease the fan speed. Pressing this switch cancels
automatic operation and places the system in manual
mode. Press AUTO to return to automatic operation.
If the airflow seems low when the fan speed is at
the highest setting, the passenger compartment air filter
may need to be replaced. For more information, see
Passenger Compartment Air Filter on page 3-42
and Scheduled Maintenance on page 7-4.
ªN«
(Mode): Pressing the switch and changing the
mode cancels automatic operation and places the
system in manual mode. Press the AUTO button to
return to automatic operation.
To change the current mode, select one of the following:
H
(Vent): This mode directs air to the instrument
panel outlets.
%
(Bi-Level): This mode directs about half of the air to
the instrument panel outlets, and then directs most of the
remaining air to the floor outlets. In automatic operation,
cooler air is directed to the upper outlets and warmer air
to the floor outlets.
6
(Floor): This mode directs most of the air to the
floor outlets with some air directed to the side window
outlets, and some of the air directed to the windshield.
The mode switch can also be used to select the
defog mode. Information on defogging and defrosting
can be found later in this section.
3-39