Turn Signal/Multifunction Lever; Turn And Lane-Change Signals - Cadillac 2008 XLR Owner's Manual

Turn Signal/Multifunction Lever

The lever on the left side of the steering column
includes the following:
•
G Turn and Lane-Change Signals. See Turn
and Lane-Change Signals on page 3-8.
•
3 Headlamp High/Low-Beam Changer. See
Headlamp High/Low-Beam Changer on page 3-9.
•
-
Fog Lamps. See Fog Lamps on page 3-30.
•
Flash-to-Pass Feature. See Flash-to-Pass on
page 3-9.
I
•
Cruise Control. See Cruise Control on
page 3-12.
P
•
Exterior Lamps Control. See Exterior Lamps
on page 3-28.
3-8

Turn and Lane-Change Signals

The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the multifunction lever all the
way up or down. When the turn is finished, the lever will
return automatically.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by itself
when you release it.
If you signal a turn or a lane change and the arrows
flash faster than normal, a signal bulb may be burned
out. Other drivers will not see the turn signal.
Replace burned-out bulbs to help avoid possible
accidents. If the arrows do not go on at all when you
signal a turn, check the fuses and check for burned-out
bulbs. See Fuses and Circuit Breakers on page 6-90.
An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.