Cadillac 2004 SRX Owner's Manual page 381

5. Start with the left (driver's side) front tire.
6. Remove the valve cap from the valve stem.
Activate the TPM sensor by increasing or
decreasing the tire's air pressure for 5 seconds,
or until a horn chirp sounds. The horn chirp, which
may take up to 30 seconds, confirms that the
sensor identification code has been matched to this
tire position. To decrease the tire's air-pressure
use the pointy end of the valve cap, a pencil-style
air pressure gage or a key.
7. Proceed to the right (passenger's side) front tire,
and repeat the procedure in step 6.
8. Proceed to the right (passenger's side) rear tire,
and repeat the procedure in step 6.
9. Proceed to the left (driver's side) rear tire, and
repeat the procedure in step 6.
10. After hearing the confirming double horn chirp,
for the left rear tire, exit the matching process
by turning the ignition switch to OFF.
11. Set all four tires to the recommended air pressure
level as indicated on the tire and loading information
label.
12. Put the valve caps back on the valve stems.
The spare tire does not have a TPM sensor. If you
replace one of the road tires with the spare, the
SERVICE TIRE MONITOR message will be displayed
on the DIC screen. This message should go off
once you re-install the road tire containing the TPM
sensor. The SERVICE TIRE MONITOR message is
also displayed when the TPM system is malfunctioning.
One or more missing or inoperable TPM sensors will
cause the service tire monitor message to be displayed.
See your dealer for service.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. this device may not cause interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. this device may not cause interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes or modifications to this system by other than
an authorized service facility could void authorization to
use this equipment.
5-71