Leaving Your Vehicle; Remote Keyless Entry System - Cadillac 2003 CTS Owner's Manual

When you want to open a rear door when the security
lock is on, do the following:
1. Unlock the door using the remote keyless entry
transmitter, the front door power lock switch or by
lifting the rear door manual lock.
2. Then open the door from the outside.
To cancel the rear door security lock, do the following:
1. Unlock the door and open it from the outside.
2. Insert your key into the slot next to the rear door
security lock label and turn it to disengage the lock.
3. Repeat the steps for the other lock.
The rear door locks will now work normally.
Anti-Lockout Feature
The power door lock switches will not work if the key is
in the ignition, the engine is off, a door is open and
delayed locking is turned off. If you press the power
door lock switch, all the doors will lock and only the
driver's door will unlock. If you close the doors, you can
lock them using the remote keyless entry transmitter. Be
sure to remove the key from the ignition when locking
your vehicle.
-
The anti lockout feature can be overridden by pressing
the lock button on the remote keyless entry transmitter.
2-10

Leaving Your Vehicle

If you are leaving your vehicle, open the door, lock the
vehicle from the inside; then get out and close the door.

Remote Keyless Entry System

With this feature, you can lock and unlock the doors or
the trunk and turn on your vehicle's interior lamps from
about 10 feet (3 m) away using the remote keyless entry
transmitter supplied with your vehicle.
Your remote keyless entry system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with RSS
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation of
the device.
-
210 of Industry Canada.