Cadillac 2002 DeVille Owner's Manual page 349

10. Install the new bulb into the socket. Make sure that
the bulb is locked in firmly.
11. Reinstall the headlamp housing socket into the
headlamp assembly.
12. Reinstall the headlamp assembly by reversing
Steps 2 through 6.
9. Pull the old bulb out of
the socket.
To reinstall the filler panel, do the following:
1. Place the filler panel in the correct location.
-
2. Reset each push pin by holding each by the outer
circle while pushing up on the pin assembly from
below. The center portion of the push
now be above the outer circle.
3. After placing each push
down on the outer circle until it is seated against the
surface of the filler panel.
-
4. Lock each push pin in place by pressing the center
of each down until it is level with the outer circle.
Use care not to press down so far that the push
releases again.
-
pin should
-
pin into the opening, press
-
pin
6-39