Firmware Renewal Mode - Philips 43PFL4901/F7 Service Manual

Equipment Required
a. USB storage device
b. Remote Control Unit
Firmware Update Procedure
User Upgrade (Filename example: PHL-0C0HD_0**_*.upg)
Upgrade the firmware only. The setting values will not be initialized.
Update procedure
1. Plug the AC Cord and turn the power on.
2. Insert the USB storage device to the USB port as
shown below.
Rear Cabinet
(example)
3. Press the [MENU] button on the remote control
unit.
4. Select "Setup" and press the [OK] button to display
the setup menu.
5. Select "Update software" and press the [OK]
button on the remote control unit.
6. Select "USB" and press the [OK] button on the
remote control unit to enter the update mode.
Update file selection screen appears as follows.
(Files included in the USB storage device are
displayed.)
Software update
Select a file
***-*****_***_*.upg
Cancel
1
Note: To cancel the update mode, select "Cancel"
and press the [OK] button.

FIRMWARE RENEWAL MODE

USB port
USB storage
device
" * " differs depending on the models.
2 4 3
7. Select the file and press [OK] button.
8. The update will start and the following will appear
in the screen.
Software update
Current Version
New Version
Are you sure you want to update?
No
1 2
Note: If the above screen isn't displayed, repeat
from step 1.
9. Select "Yes" and press the [OK] button to update.
Note: Do not remove the USB storage device or
turn the TV off while update is in progress.
10. When the firmware update is completed, the
following will appear in the screen.
Software update
Software update is successful.
Please remove the USB storage device and restart the TV set.
1 3 2
Remove the USB storage device from the USB
port.
Turn the power off and turn the power on again.
7-1
" * " differs depending on the models.
***-*****_***_*
***-*****_***_*
Yes
3
" * " differs depending on the models.
PL15.13-A_FW
4
4