Advertisement
3. Decide which one of the three channels you want to program. Using
both hands, press the hand-held transmitter button and the desired
button on the HomeLink
TM
Transmitter. Continue to hold both
buttons through Step 4.
4. Hold down both buttons until you see the red light on the HomeLink"
-
Transmitter flash rapidly. The rapid flashing, which could take up to
90 seconds, indicates that the HomeLink" Transmitter has been
programmed. Release both buttons once the light starts to flash rapidly.
-
If you have trouble programming the HomeLink
TM
Transmitter, make
sure that you have followed the directions exactly as described and that the
batteries in the hand-held transmitter are not dead. If you still cannot
program it, rotate your hand-held transmitter end over end and try again.
The HomeLink
TM
Transmitter may not work with older garage door
openers that do not meet current Federal Consumer Safety Standards. If
you cannot program the transmitter after repeated attempts, consult your
Cadillac dealer or call 1-800-355-35 15.
Be sure to keep your original hand-held transmitter in case you need to
-
erase
and
reprogram
the
HomeLink
TM
transmitter.
- 1
Note to Canadian Owners: During programming, your hand-held transmitter
may stop transmitting after one or two seconds. If you are programming
-
from one of these transmitters, the HomeLink indicator light
may prompt
you to re-activate your hand-held transmitter with a series of double blinks.
After you re-activate your hand-held transmitter, the HomeLink
TM
light
should flash rapidly. If it flashes slowly, continue to periodically re-activate
your hand-held transmitter until the light flashes rapidly.
Operating the Transmitter
Press the appropriate button on the HomeLink
TM
Universal Transmitter.
The red light comes on while the signal is being transmitted.
Note that the effective transmission range of the HomeLink" Transmitter
may differ from your hand-held transmitter and from one channel to another.
-
Emsing Channels
To erase all three programmed channels, hold down the two outside
buttons until the red light begins to flash. Individual channels cannot be
erased, but can be reprogrammed using the procedure for programming
the transmitter explained earlier.
-
2-70
Advertisement
