Enabling The Persistent Mac Address Feature - Cisco Catalyst 3560CX Series Manual

Enabling the Persistent MAC Address Feature

Command or Action
Device(config)# end
Step 5
show switch horizontal-stack-ports
Example:
Device# show switch hstack-ports
Step 6 copy running-config startup-config
Example:
Device# copy running-config startup-config
Step 7
reload
Example:
Device# reload
What to do next
To convert a stack port into a network port, run the no switch switch-number hstack-port stack-port command:
Device(config)# no switch 1 hstack-port 1 TenGigabitEthernet 1/0/1
Device# copy running-config startup-config
Device# reload
Note
After configuration, restart the switch to convert the stack port into a network port.
Note Stack port to network port conversion and vice versa cli is not nvgened. On write erase reload, the switch in
stack mode will not be converted to standalone, and manual conversion of stack port to network port is required.
Enabling the Persistent MAC Address Feature
Note When you enter the command to configure this feature, a warning message appears with the consequences of
your configuration. You should use this feature cautiously. Using the old active switch MAC address elsewhere
in the same domain could result in lost traffic.
Follow these steps to enable persistent MAC address:
Managing Switch Stacks
12
Purpose
Verifies the operation status of network ports and stack
ports.
(Optional) Saves your entries in the configuration file.
Reloads the configuration.
Managing Switch Stacks