Nintendo TWL-001 Operation Manual page 45

Internet
Advanced Setup
In Advanced Setup you can configure settings for connecting to the internet using
software that supports Nintendo DSi features, using WPA level high security, proxy
settings and settings for connecting with WPS.
Advanced Setup (connections 4 – 6) cannot be used with Nintendo DS software
that does not support Nintendo DSi features. When connecting to the internet with
Nintendo DS/DS Lite software, configure normal internet settings (connections 1 – 3).
How to Connect
1 Touch CONNECTION SETTINGS.
2
Touch ADVANCED SETUP.
3
Touch an open connection, indicated by
NONE.
4
Touch the connection method best suited
for your connection environment.
To set up using WPS
Touch the WPS icon and proceed
from step .
5
Page 82 ➜
• Using AOSS
• Searching for an access point
Page 86 ➜
• Manual setup
88
Page 94 ➜
Note: The following instructions are
the same as for configuring normal
Page 84 ➜
settings.
5 Touch the connection type best suited for
your access point.
Access point steps
6
Push-Button Connection
Continue to push the WPS Button
until the lamp blinks.
It may take as long as 2 minutes until setup completes.
8 Touch OK to perform a connection test.
If the connection test is successful, setup is complete
Immediately after completing settings using WPS, connection may fail due
to the restarting of the access point. Wait a short time, then try performing
a connection test again.
Pin connection
Set the PIN number displayed on the
Nintendo DSi system's Touch Screen
in your access point.
7
Touch NEXT.
89