Advertisement
C. Calculate the correct length to cut the housing extrusion and pushbar extrusion using the door
width as determined in step 1 (dimension "X").
CHANNEL EXTRUSION
PUSHBAR EXTRUSION
EXTRUSION LENGTH = "X" - 4
"
13/16
D. Calculate the correct length to cut the cover plate extrusion using the door width determined in
step 1.
COVER PLATE
COVER PLATE LENGTH = "X" - 20
"
7/8
E. Cut metal parts to length determined above (using a metal miter saw is recommended to
ensure a good clean cut and a right angle). Do not cut the plastic push pad.
F. Reassemble the TouchBar (without installing the end caps). Note that the screws which connect
parts to the aluminum extrusions are self tapping (thread forming) screws. It is recommended that
a power tool be used to drive them in. This will make assembly easier.
NOTE: AT THIS TIME THE TOUCHBAR CAN BE HANDED BY ASSEMBLING THE
"PUSH TO EXIT" SIGN (IF FURNISHED) IN THE CORRECT ORIENTATION.
3
Advertisement
