Advertisement
STEP 1
Place the TouchBar on the door and measure the distance
between each end and the stop (or frame on a blade stop
door). It should be at least 3/8" of an inch. If so, proceed
to step 2. If not, the TouchBar will need to be cut to size.
CUTTING TOUCHBAR TO SIZE:
A. Measure the DOOR WIDTH, hereafter referred
to as dimension "X"
B. Disassemble the TouchBar as shown below:
1.
REMOVE END CAPS AND BRACKETS
2.
REMOVE PIVOT HINGE COMPONENTS AND
.
SWITCH COMPONENTS
HINGE AND SWITCH ASSEMBLIES TOGETHER
WHEN DISASSEMBLING DEVICE
SWITCH SIDE END CAP
COVER PLATE
3.
SLIDE OUT PUSH PAD AND EXIT SIGN
(
IF FURNISHED
.
COVER PLATE
SEE BACK COVER FOR COMPLETE EXPLODED VIEW.
2
.
KEEP THE PIVOT
.
)
.
AS SHOWN
SLIDE OUT
SWITCH LEVER
SWITCH
3/8"(min)
HOLLOW METAL OR WOOD DOOR
SWITCH ASSEMBLY
CROSS SECTION OF SWITCH AREA
DIMENSION "X"
CHANGING HAND:
1. REMOVE SWITCH SIDE
END CAP AND PUSHBAR
END CAP.
PUSHBAR
:
END CAP
2. REMOVE "PUSH TO EXIT"
SEE INSET
SIGN AND INSERT AND
BELOW
REVERSE LETTER DIREC-
INSERT
TION.
3. REFER TO THIS PAGE TO
RE-INSTALL END CAPS.
PUSH PAD
:
SLIDE PUSHBAR END CAP UNDER
SWITCH LEVER AND CAPTURE
.
SPRING
PUSHBAR END CAP
SPRING
SWITCH ADJUSTMENT SCREW
PUSHBAR END CAP BRACKET
3/8"(min)
:
Advertisement
