Table of Contents
Advertisement
Advanced Fax
1
Features
Advanced Copy
Features
2
System Monitor
3
Reports and Lists
4
Received faxes print blotched or unevenly.
Troubleshooting
5
Appendix
6
Table of Contents
Index
Q
Is the correct size of paper loaded in the
machine?
A
Make sure you load paper that meets the
requirements for use. (See Chapter 3, "Print
Media," in the Basic Guide.)
A
Change <REG. PAPER SIZE> in <COMMON
SETTINGS>. (See Chapter 12, "Machine Settings,"
in the Basic Guide.)
Q
Are the telephone lines in poor condition, or do
you have a bad connection?
A
Error Correction Mode (ECM) should eliminate
such problems. However, if the telephone lines are
in poor condition, you may have to try again.
Q
Is the sender's machine functioning properly?
A
Ask the sender to check that the scanning
components of the machine are clean.
Back
Q
Is the toner low or unevenly distributed?
A
Redistribute the toner inside the toner cartridge. If
the problem persists, replace the toner cartridge.
(See Chapter 10, "Maintenance," in the Basic
Guide.)
Cannot receive using Error Correction Mode (ECM).
Q
Does the sender's machine support ECM?
A
If the sender's machine does not support ECM, the
document is received in normal mode without error
checking.
Receiving of documents is too slow.
Q
Is ECM (Error Correction Mode) set to <ON>?
A
Because ECM corrects errors during a
transmission, any problems on the line can mean
that the transmission will take extra time. Set ECM
to <OFF>.
TOP
Previous
Next
5-12
Advertisement
Table of Contents
