Table of Contents
Advertisement
Boot Options
Specifies the settings for the system startup.
Boot Options
Boot Sequence
st
1
[Floppy Disk]
nd
2
[Hard Disk]
rd
3
[IDE CD-ROM]
First Hard Disk Drive ..................[IDE]
Primary Display Adapter ................[Auto ]
Fast Boot ..............................[Auto ]
Num Lock After Boot ....................[Enabled ]
Memory Test ............................[Disabled]
*Configuration Table ...................[Enabled ]
*Boot from LANDesk Service Agent .......[Disabled]
↑↓ = Move Highlight Bar
Esc = Exit
Boot Options
Example for the
Boot Sequence
defines the sequence in which the system BIOS searches the drives for system files to start the
operating system. You can change the sequence with the
First Hard Disk Drive
Specifies whether the system is booted from an IDE or an SCSI hard disk drive.
Primary Display Adapter
Primary Display Adapter enables or disables the on-board VGA controller on the system board. If a
screen controller board is installed the on-board controller must be disabled.
Fast Boot
Fast Boot can reduce the extent of the self-test and thus accelerate the system startup.
When Auto is set, the fast self test is performed. When Disabled is set, the complete device
configuration is tested, when the device is switched on.
A26361-K522-Z120-2-7419
Page 1/1
submenu
F1 = Help
→ ← = Change Setting,
and
key.
Boot Options
English - 23
Advertisement
Table of Contents
