Setting Jumper Switches - IBM M768MR User Manual

M768MR Mainboard User's Manual

Setting Jumper Switches

Jumpers are sets of pins which can be connected together with
jumper caps. The jumper caps change the way the mainboard
operates by changing the electronic circuits on the mainboard. If a
jumper cap connects two pins, we say the pins are SHORT. If a
jumper cap is removed from two pins, the pins are OPEN.
JP3
1
1
JP1
Jumper JP1: Clear CMOS Memory
Use this jumper to clear the contents of the CMOS memory. You
may need to clear the CMOS memory if the settings in the Setup
Utility are incorrect and prevent your mainboard from operating.
To clear the CMOS memory, disconnect all the power cables from
the mainboard and then move the jumper cap into the CLEAR
setting for a few seconds.
Function
Normal Operation
Clear CMOS Memory
Jumper JP2: Keyboard Power On Selector
If you enable the keyboard power on feature, you can use hot keys
on your keyboard as a power on/off switch for the system.
Note: The system must provide 1A on the +5VSB (+5V Standby)
signal before using the Keyboard Power On function.
Function
Enable Keyboard Power On
Disable Keyboard Power On
12
Jumper Setting
Short Pins 1-2
Short Pins 2-3
Jumper Setting
Short Pins 1-2
Short Pins 2-3
1
JP2
1
JP5